PAGT/B1 Patch App & Go T1 Smart Network Tester & Tracer with 12 Smart Remote Plugs

The Patch App & Go Tester is suitable for confirming the correct wiring of terminated cables, typically between an RJ45 patch panel and user outlet, such as those found in Cat 5e, Cat 6 and Cat 6A unshielded and shielded networks. As the device performs each test the results appear as a pass or fail on your mobile device. When a fail is reported, the app will visually display the fault, instantly identifying wiremap errors such as mis-wires, split pairs, shorts and open ends.

If a network installation has not been labelled correctly or you need to trace unidentified ports the Smart Remote Plugs make tracing from one end of the cable to the other quick and easy. Insert the Smart Remote Plugs into the patch panel and use the Patch App & Go tester to send a trace from the wall outlet on the other end of the cable back to the uniquely numbered Smart Remote Plug. The user will then be instantly notified of which number plug it has found, allowing the link to be identified and labelled.

Features include:

• Free app displays live test summary of passes, failures and number of tests remaining
• Visual wiremap for good termination, cross pairs and open wire
• Automatically produces PDF site test report which can be e-mailed or printed
• Quickly trace unidentified cables
• Save site test data for later review
• In app chat and help functions

Pack Contents:

• Patch App & Go Network Tester & Tracer
• 12 x Smart Remote Plugs individually programmed with numbers 1 to 12
• USB Charging cable
• Soft Carry Case

Prior to testing, please ensure that there are no Power over Ethernet (PoE) devices plugged into the network you are about to test. Blowing your T1 or Remote Plugs are not covered under the warranty

Documentation:

Datasheet: Patch_App_Go_T1_Data_Sheet_1